引用本文:
【打印本页】   【HTML】   【下载PDF全文】   View/Add Comment  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 3245次   下载 1677 本文二维码信息
码上扫一扫!
分享到: 微信 更多
沉积温度对钢球表面含氢碳薄膜结构和摩擦学性能的影响
付宇1,2, 路阳1, 杨效田1, 王永富2, 张俊彦2
1.兰州理工大学 材料科学与工程学院, 兰州 730050;2.中国科学院兰州化学物理研究所 固体润滑国家重点实验室, 兰州 730000
摘要:
目前,含有类富勒烯碳结构的氢化碳薄膜(FL-C:H)主要通过等离子体增强化学气相沉积技术(PECVD)在单晶硅表面制备。文中在碳薄膜PECVD沉积工艺之前,通过额外引入原位渗氮方法在钢球表面沉积过渡层以增强薄膜与基材结合力,从而成功制备了具有类富勒烯结构的含氢碳薄膜。通过改变钢球表面碳膜沉积时间(30、60、90、120、150和180 min)获得厚度不同、结构变化的碳膜,进而研究碳膜的结构演变与摩擦学性能之间的关系。结果表明:FL-C:H薄膜PECVD沉积工艺(采用了比额外引入的原位渗氮工艺更低的基底偏压)使钢基底温度随沉积时间增加而下降,导致薄膜结构转变。碳膜结构最初为类石墨结构,随着沉积时间的增长逐渐转变为类富勒烯结构;沉积时间为180 min的碳基薄膜具有超低摩擦因数(0.009)和超长磨损寿命(53 000个周期)。
关键词:  超低摩擦  含氢碳膜  类石墨  类富勒烯
DOI:10.11933/j.issn.1007-9289.20180213001
分类号:TG174.444;TG115.58
基金项目:国家自然科学基金(中瑞:51611530704;中俄:51661135022)
Effects of Deposition Temperature on Structure and Tribological Properties of Hydrogenated Carbon Films on Steel Balls
FU Yu1,2, LU Yang1, YANG Xiao-tian1, WANG Yong-fu2, ZHANG Jun-yan2
1.College of Materials and Engineering, Lanzhou University of Technology, Lanzhou 730050;2.State Key Laboratory of Solid Lubrication, Lanzhou Institute of Chemical Physics, Chinese Academy of Sciences, Lanzhou 730000
Abstract:
Currently, hydrogenated carbon films containing the fullerene-like structures (FL-C:H) are mainly prepared on single-crystal Si substrates by plasma enhanced chemical vapor deposition (PECVD). In-situ plasma nitriding was additionally introduced prior to the PECVD process, to enhance the adhesion between the carbon films and steel substrates. The samples were prepared with different deposition times (30, 60, 90, 120, 150 and 180 min). Thickness, nanostructural evolution and tribological behavior of the coating were investigated. The results show that the FL-C:H film PECVD deposition process causes the temperature of the steel substrate to decrease as the deposition time increases (using a lower substrate bias than the extra in-situ nitriding process introduced), resulting in the structure transformation of the film. The films precent a graphite-like structure at the starting stage and gradually transform into a fullerene-like structure. The films deposited for 180 min exhibit super-low friction (0.009) and superlong wear life (53 000 cycles).
Key words:  super-low friction  hydrogenated carbon film  graphite-like  fullerene-like