| 摘要: |
| 纳米多层膜因具有优异的力学性能与抗摩擦磨损性能使其在摩擦学领域具有重要的应用价值。采用磁控溅射沉积法制备了Al、AlN单层薄膜与Al/AlN纳米多层膜，探讨了纳米多层化对薄膜的力学性能和摩擦学性能的影响。采用纳米压痕仪和摩擦磨损试验机测量评价薄膜的纳米硬度和摩擦学性能。结果表明：Al/AlN纳米多层膜具有良好的周期调制结构，多层膜中的大量界面能显著提高薄膜的力学性能与摩擦学性能。多层膜的硬度为8.8 GPa，高于采用混合法则计算出的硬度值6.6 GPa；多层膜具有软质Al层和硬质AlN层的交替结构，在摩擦过程中，硬质AlN层可以起到良好的承载作用，软质层可以起到良好的减摩作用。相对于Al单层薄膜或AlN单层薄膜，Al/AlN纳米多层膜具有较低的摩擦因数(0.15)和优异的抗磨损性能。 |
| 关键词: 磁控溅射 Al/AlN多层膜 摩擦学性能 |
| DOI：10.11933/j.issn.1007-9289.2016.01.009 |
| 分类号: |
| 基金项目: |
|
| Tribological Properties of Al/AlN Multilayers Prepared by Magnetron Sputtering Technique |
|
WANG Yunfeng, ZHANG Guangan, WU Zhiguo1,2,3
|
|
1. Key Laboratory of OptoTechnology and Intelligent Control Ministry of Education, Lanzhou Jiaotong University, Lanzhou 730070;2. State Key Laboratory of Solid Lubrication, Lanzhou Institute of Chemical Physics, Chinese Academy of Sciences, Lanzhou 730000;3. School of Physical Science and Technology, Lanzhou University, Lanzhou 730000
|
| Abstract: |
| Multilayers have been paid extensive attention to the triblogical applications due to their excellent mechanical properties and antiwear properties. Al, AlN single layer and Al/AlN multilayers were prepared by magnetron sputtering method. The mechanical and wear properties of the multilayer were discussed. The hardness of the Al/AlN multilayer films was determined using a nanoindentation tester. The tribological properties of the films were measured by a UMT2MT tester in reciprocating mode. The asdeposited Al/AlN multilayers show welldefined multilayer modulation structures. The mechanical properties of the Al/AlN multilayers significantly improved, which is caused by the large content of interfaces. The hardness of the Al/AlN multilayers is 8.8 GPa, which is higher than the calculated hardness (6.6 GPa) using the ruleofmixture with the single layer. In the Al/AlN multilayers, the hard AlN layer shows superior carrying capacity, while the soft Al layer plays a lubricant role in the wear process. Therefore, the Al/AlN multilayers show lower friction coefficient (0.15) and much better wear resistance than the single layers. |
| Key words: magnetron sputtering Al/AlN multilayers tribological properties |
