引用本文:徐进,朱旻昊,周仲荣,石心余,刘家浚.电刷镀铅-镍复合镀层微动磨损性能研究[J].中国表面工程,2002,(1):29~31
.An Investigation of Fretting Behavior of Pb/Ni Composite Coating Prepared by Electro-brush Plating[J].China Surface Engineering,2002,(1):29~31
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被：浏览 3501次   下载 83次 本文二维码信息
码上扫一扫！
分享到： 微信 更多
字体:加大+|默认|缩小-
电刷镀铅-镍复合镀层微动磨损性能研究
徐进,朱旻昊,周仲荣,石心余,刘家浚
作者单位
摘要:
应用电刷镀技术，镍作为过渡层，制备了铅－镍复合镀层，考察了该复合镀层微动摩损性能，并与基体微动磨损性能进行了比较，结果表明，在基体表面电刷镀铅－镍复合镀层具有较好的抗微动磨损性能，其损伤机制为粘着和疲劳，镀层摩擦因数微动振增加而增加，随载荷的增加而减小；涂层明显改变了表面的摩擦状态，在微动磨损过程中减轻了表面粘着，降低了磨损。
关键词:  电刷镀 铅－镍复合镀层 微动磨损性能
DOI：
分类号:TG115.58 TQ153.2
基金项目:国家杰出青年科学基金资助项目(59725513)
An Investigation of Fretting Behavior of Pb/Ni Composite Coating Prepared by Electro-brush Plating
XU Jin  ZHU Min-hao  ZHOU Zhong-rong  SHI Xin-yu  LIU Jia-jun
Abstract:
A Pb/Ni composite coating was prepared by electro-brush plating. The fretting wear properties of the composite coating was investigated and compared with that of steel substrate. The main results showed that the composite coating has good anti-fretting properties , and its main damage mechanism is adhesion and fatigue wear. The friction coefficient increases with the increase of amplitude, and decreases with the increase of load. The composite coating can obviously change the surface friction state, and alleviate the adhesion and fatigue wear of surfaces.
Key words:  electro-brush plating,Pb/Ni composite coating,fretting wear
手机扫一扫看