引用本文:李亚东,王怀亮.火焰喷涂经1010／石墨复合涂层摩擦,磨损性能的研究[J].中国表面工程,2000,(2):30~32
.The Study on the Properties of Resistance to Wear of Nylon1010/Graphite Coating by Flame Spraying[J].China Surface Engineering,2000,(2):30~32
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被：浏览 3026次   下载 95次 本文二维码信息
码上扫一扫！
分享到： 微信 更多
字体:加大+|默认|缩小-
火焰喷涂经1010／石墨复合涂层摩擦,磨损性能的研究
李亚东,王怀亮
作者单位
摘要:
借助Ａｍｓｌｅｒ２０００磨损试验机等，对火焰喷涂尼龙１０１０／石墨复合涂层的摩擦磨损进行了研究，结果表明：该复合涂层较纯尼龙龙涂层更加优异的耐磨、减摩性能，在１．２ｍｓ＾－１，１２００Ｎ时，与４５钢的摩擦因数小于０．０５，１ｈ内磨损量低于１．２ｍｇ。
关键词:  火焰喷涂 复合涂层 摩擦磨损 尼龙1010／石墨
DOI：
分类号:TG174.442
基金项目:河南省自然科学基金资助项目(984042300)
The Study on the Properties of Resistance to Wear of Nylon1010/Graphite Coating by Flame Spraying
Li Yadong  Du Qingbo  Wang Huailiang
Abstract:
The properties of resistance to rub and wear of nylon1010/graphit coating by flame spraying were studied by wear-test machine of amsler. The results showed that the coating had more excellent resistance to rub and wear than pure Nylon1010 coating. The friction coefficient between coating and steel less than 0.05 at the speed of 1 .2ms-1 and the load of 1200N, and the weight loss was less than 1 .2mg in one hour.
Key words:  flame spraying, coating, rubaud wear. nylon1010/graphit
手机扫一扫看