引用本文:伞金福,杜智,毕志夫.电弧喷涂不锈钢工艺对涂层孔隙率和氧化物含量的影响[J].中国表面工程,1997,(3):
.Effect of Spraying Parameters on Porosity and Oxides Content of Arc-sprayed Stainless Steel Coatings[J].China Surface Engineering,1997,(3):
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被：浏览 3440次   下载 81次  
分享到： 微信 更多
字体:加大+|默认|缩小-
电弧喷涂不锈钢工艺对涂层孔隙率和氧化物含量的影响
伞金福,杜智,毕志夫
作者单位
摘要:
本文利用OMNICON5000图像分析仪测定了电弧喷涂3Cr13和1Cr18Ni9Ti不锈钢涂层的孔隙率和氧化物含量，考察了喷涂工艺参数对其影响。研究结果为正确控制电弧喷涂工艺提供了实验依据。
关键词:  电弧喷涂,不锈钢涂层,孔隙率,氧化物
DOI：
分类号:TG17
基金项目:
Effect of Spraying Parameters on Porosity and Oxides Content of Arc-sprayed Stainless Steel Coatings
San Jinfu, Du Zhi Tsing Hua UniversityBi Zhifu He Bei Research Center of Surface Technology
Abstract:
In this paper, the porosity and oxides content ofArc - sprayed 3Cr13 and 1Cr18Ni9Ti Stainless Steel Coatings were tested by an OMNICON5000 medel image ana-lyzer, and effect of spraying parameters on them was stud-ied. The research result provides experimental basis forcontrolling are spraying process precisely.
Key words:  Are spraying, Stainless Steel, Coatings Porosity, Oxides
手机扫一扫看