引用本文: | 刘宪军,陈字刚,马世宁,徐滨士.应用电弧喷涂技术制作塑料加工用模具的试验研究[J].中国表面工程,1995,(4): |
| .An Experimental Study on Arc Spraying Mould Making for Plastic Products[J].China Surface Engineering,1995,(4): |
|
|
摘要: |
应用电弧喷涂制作塑料加工用模具(电弧喷涂制模)是一种快速、低成本制作塑料加工用模具的有效技术、本文根据对此项技术的试验研究结果,介绍了电弧喷涂制模技术中,脱模剂的选择;浇注填充材料的选择;制模工艺过程等。最后指出了此项技术的应用领域和发展趋势。 |
关键词: 电弧喷涂,电弧喷涂制模,脱模剂,浇注填充材料 |
DOI: |
分类号:TG174 |
基金项目: |
|
An Experimental Study on Arc Spraying Mould Making for Plastic Products |
Xianjun Liu Zigong Chen
|
Abstract: |
Arc spraying mould making for plastic products is low cost,efficient technique. According to tested results the paper presents how to select release agents; how to select backup materials; mould making procedures ect. in arc spraying mould making. Application and development of arc spra-ying mould making are also indicated at the end of this paper. |
Key words: Are spraying Are spraying mould making Release agents Backup materials |